English
8
• Press the VEL key, both OCT buttons will flash.
• Enter your velocity response selection by using the keys marked from 0 to 5.
• Press the ENTER/YES key to con firm your input. The Up OCT button will flash to show the setting has been
accepted, and iRig KEYS 25 will automatically exit EDIT mode.
Assign a specific MIDI control change number to the VOL/DATA knob
By default, the VOL/DATA knob sends MIDI Volume messages which are assigned to MIDI Controller #7.
However, you can customize the MIDI Controller number that is associated with the VOL/DATA knob.
To assign a Controller number to the KNOB:
• Enter EDIT mode.
• Press the KNOB key, both OCT buttons will flash.
• Enter the MIDI CC number you need using the keys marked from 0 to 9. Valid numbers are from 0 to 127, so
you can enter up to three digits consecutively when needed.
• Press the ENTER/YES key to confirm your input. The Up OCT button will flash to show the setting has been
accepted, and iRig KEYS 25 will automatically exit EDIT mode.
Send specific MIDI program changes numbers
Program Changes are sent directly by sending a specific Program Change number from within EDIT mode.
To send a specific Program Change number:
• Enter EDIT mode.
• Press the PROG key, both OCT buttons will start flashing.
• Enter the Program Change number using the keys marked from 0 to 9. Valid numbers are from 1 to 128, so
you can enter up to three digits consecutively when needed.
• Press the ENTER/YES key to con firm your input. The Up OCT button will flash to show the setting has been
accepted, and iRig KEYS 25 will automatically exit EDIT mode.
Reset iRig KEYS 25
iRig KEYS 25 can be reset to its original factory state.
To reset iRig KEYS 25:
• Enter EDIT mode.
• Press the RESET key. The Up OCT button will flash to show the setting has been accepted, and iRig KEYS
25 will automatically exit EDIT mode.
Troubleshooting
iRig KEYS 25 doesn’t play my instrument even if though it is turned ON.
Make sure the MIDI Transmit Channel matches the receiving MIDI channel of your instrument. See the
paragraph “Set MIDI transmit channel”.
To Next Page
Loading...
Need help?
General
