IKA G-L - Intended Use

8 9
Intended use
/// Use
› The IKA G-L centrifuge is suitable for separating of substances and mixtures of substances of
various densities�
› Intended use: Tabletop device
/// Area of use (only indoors)
› Laboratories
› Pharmacies
› Universities
› Schools
The device is suitable for all areas (EMC class A and B)�
The safety of the user cannot be guaranteed:
› if the device is operated with accessories that are not supplied or recommended by the
manufacturer�
› if the device is operated improperly or contrary to the manufacture’s specifications�
› if the device or the printed circuit board are modified by third parties�
/// Disposal instructions
› The device, accessories and packaging must be disposed of in accordance with local and
national regulations�
/// Maintenance
› The device must only be opened by trained specialists, even during repair� The device must
be unplugged from the power supply before opening� Live parts inside the device may still
be live for some time after unplugging from the power supply�
/// Accessories
› Protect the device and accessories from bumping and impacting�
› Check the device and accessories beforehand for damage each time when you use them� Do
not use damaged components�
› Safe operation is only guaranteed with the accessories described in the ”Accessories” section�
› Disconnect the power plug before attaching or changing any accessories�
/// Power supply / switching off the device
› The voltage stated on the type plate must correspond to the power voltage�
› The device can only be disconnected from the power supply by pulling out the power plug
or the connector plug�
› The device must only be operated with the original power cord set�
› The socket for the power cord must be easily accessible�
› The device does not start up again automatically following a cut in the power supply�
Warning!
› When centrifuging hazardous substances or mixtures of substances which are toxic or are
contaminated with pathogenic micro-organisms, the user should take appropriate precau-
tions� In such cases, centrifuging vessels with special screw seals for hazardous substances
must always be used�
› For materials in risk groups 3 and 4, in addition to sealed centrifuging vessels a bio-safety
system must be used (see the “Laboratory Biosafety Manual” issued by the World Heath
Organisation)� No biosafety systems are available for this centrifuge�
!
Notice!
› Before starting the device for the first use, make sure that the rotor nut is securely fastened�
Fail to do it, can result in permanent damage to the device and accessories�
› The rotor is subjected to extreme forces� Serious internal material damage can occur as a
result of even slight scratches and cracks� Do not use the device if the rotor is damaged�
› Do not operate the centrifuge if there is evidence of damage to the centrifuge chamber�
› Do not process materials that are radioactive, flammable or explosive, or materials that react
chemically with each other releasing large amounts of energy�
› If unusual noises occur when the centrifuge is started, the rotor is not secured correctly� In
this case, immediately stop the centrifuge�
› Covers or parts that can be removed from the device without tools must later be refitted to
ensure safe operation� This will prevent the infiltration of foreign objects, liquids and other
contaminants�
› Prior to centrifugation, the tubes should be visually inspected for any physical damage�
Broken tubes can damage centrifuge and accessories�
› If you are using aggressive chemicals, protect the device from being damaged by these
chemicals�
› Only process media that will not react dangerously to the extra energy produced through
processing� This also applies to any extra energy produced in other ways, e�g� through light
irradiation�
› Always use rotor cover along with the rotor�
› Inspect the rotor and rotor cover regularly�
› Do not run the motor without rotor�
› The device must be supervised when it is running�
› While the centrifuge is running, do not move it or strike it�
› The feet of the device must be clean and undamaged�