IKA PETTE - Material and Cleaning Information; Pipette Parts Materials; Cleaning and Autoclaving

36 37
1,5 x
12
90°
10
13
11
14
/// Materials of pipette parts
› Stainless Steel
› DLC-coating (diamond-like carbon)
› PVDF (polyvinylidenfluoride)
› PTFE (polytetrafluorethylene)
› PEEK (polyetheretherketone)
› PEI (polyetherimide)
› Fluoroprene XP 40
› PSU (polysulfone)
› PP (polypropylene)
› PC (polycarbonate)
› LSR (liquid silicone rubber)
› PE (polyethylene) - Filter
› PPS (Polyphenylensulfid)
› PPSU (Polyphenylsulfone)
/// Cleaning
Caution!
› Wear protective gloves during cleaning the devices�
› Disassemble the lower part of the pipette as shown�
› Clean the parts with surfactant-containing water (soap solution) or isopropanol (70%)�
› Rinse the parts with distilled water and let them dry�
› Before using another than the recommended method for cleaning or decontamination, the user
must ascertain with IKA that this method does not destroy the device�
/// Autoclaving
!
Notice!
› Remove the filter before autoclaving and replace it after autoclaving�
(IKA PETTE vario 0,5 - 5 ml / 1 - 10 ml)
› All pipette parts fully autoclavable at: 121 °C; 20 min; 1 bar overpressure�