Problem Possible cause Remedy
The hob deactivates. You put something on the
symbol
Remove the object from the
symbols.
The power setting changes
between two levels.
Power exchange function
operates.
Refer to "Daily use" chapter.
The symbols become hot. The cookware is too large or
you put it too near to the
controls.
Put large cookware on the
rear zones if possible.
There is no signal when you
touch a symbol on the con-
trol panel.
The signals are deactivated. Activate the signals.
Refer to "Daily use" chapter.
The flexible induction cook-
ing area does not heat up
the cookware.
The cookware is in the
wrong position on the flexi-
ble induction cooking area.
Place the cookware in the
correct position on the flexi-
ble induction cooking area.
The position of the cookware
depends on the activated
function or function mode.
Refer to "Flexible induction
cooking area" chapter.
The diameter of the bottom
of the cookware is incorrect
for the activated function or
function mode.
Use cookware with diameter
applicable to the activated
function or function mode.
Use cookware with diameter
smaller than 160 mm on a
single section of the flexible
induction cooking area.
Refer to "Flexible induction
cooking area" chapter.
comes on.
Automatic Switch Off oper-
ates.
Deactivate the hob and acti-
vate it again.
comes on.
The Child Safety Device or
the Lock function operates.
Refer to "Daily use" chapter.
comes on.
There is no cookware on the
zone.
Put cookware on the zone.
The cookware is incorrect. Use the correct cookware.
Refer to “Hints and tips”
chapter.
ENGLISH 21
To Next Page
Loading...
