SETTING UP YOUR REMOTE CONTROL:
Before you can use your remote control you
will need to complete a one-time set-up
process to pair the remote with the lights.
1. The UTRUSTA worktop light and the
ANSLUTA transformer are equipped with
a small sensor button. Press the sensor
once and it will light up.
2. Next press the remote control for a
blinking signal.
Repeat the same procedure for each
UTRUSTA worktop light unit and ANSLUTA
transformer installed.
3. The remote control is now set for
dimming or turning the lamps on and off.
SAVE THESE INSTRUCTIONS
FOR FUTURE USE
Technical Data
ANSLUTA remote control:
Frequency band: 2436.20 +/- 0.03 MHz
Operating frequency: 2436.20 MHz
Number of channels: 1
Transmit power: 1.26 mW
Mode of operation: Simplex
Complies with IDA Standards DA106634
ENGLISH 4
To Next Page
Loading...
Need help?
General
