The BEKANT desk is an electrical furnishing designed for use as a height-adjustable workstation, allowing users to work either sitting or standing. It is intended for indoor use in dry environments such as offices or similar settings.
Important Safety Instructions
When using the BEKANT desk, it is crucial to follow basic safety precautions. Always read all instructions before using the product.
DANGER
To reduce the risk of electric shock, always unplug the furnishing from the electrical outlet before cleaning or servicing.
WARNING
There is a risk of electric shock, fire, and injury. Review the assembly instructions to confirm that the appropriate critical components and accessories are being used with the furnishing.
- Unplug the furnishing from the outlet before putting on or taking off parts.
- Close supervision is necessary when this furnishing is used by, or near children, invalids, or disabled persons.
Risk of injury - Keep children away from extended foot support (or other similar parts).
- Use this furnishing only for its intended purpose as described in these instructions. Do not use attachments not recommended by the manufacturer.
- Never operate this furnishing if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, or dropped into water. Return the furnishing to a service center for examination and repair.
- Keep the cord away from heated surfaces.
- Do not use outdoors.
- Do not operate where aerosol (spray) products are being used or where oxygen is being administered.
- The table must not be overloaded; the maximum load is 70 kg (154 lbs).
This appliance can be used by children aged 8 years and above, and persons with reduced physical, sensory, or mental capabilities or lack of experience and knowledge, if they have been given supervision or instruction concerning the safe use of the appliance and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be performed by children without supervision.
Technical Specifications
- Sound level: Less than 55 dB(A)
- Height setting interval:
- EU-version: 64-125 cm
- NA-version: 57.4-122.4 cm (22.6-48.2 inches)
- Maximum load: 70 kg (154 lbs)
- Temperature interval at usage: +5 to +40°C (41 to 104°F)
- Temperature interval at storage: -10 to +50°C (14 to 122°F)
- Humidity: 20% to 80% at a temperature of 30°C (86°F)
Power supply unit:
- DC 25-35V, 240W
- 100-240VAC, 4A/2A
- Manufacturer: ROL ERGO
- Model: ASW0579-2902002W
- Duty Cycle: 1 minute on / 9 minutes off. This means the motors can run continuously for a maximum of 1 minute, after which they must remain off for approximately 9 minutes before being reused.
This equipment must only be used with the power supply unit provided with the product.
Installation Instructions
- The table is assembled according to separate assembly instructions.
- Connect the cable from one leg to the other. Connect the hand control to one of the legs and the power supply to the other leg. The cables connected to the legs, hand control, and power supply should be placed in the accompanying net. Position the electrical cables so that they are not damaged; refer to the assembly instructions.
- Connect the electrical cable to a wall socket.
NB: The electrical cable must have full mobility.
- Insert the safety key into the socket of the hand control.
- The table is now ready for use. The motors stop automatically when the table reaches its lowest and highest positions respectively.
Usage Features
- The table should only be used as a working table with the possibility to continuously adjust working height between sitting and standing positions.
- The table should only be used indoors and in dry premises (office environment or similar).
- The table must not be overloaded.
To adjust the table height, follow these instructions:
- Insert the safety key into the socket on the hand control.
- Make sure no objects are obstructing the table's movement.
- To move the table up or down, press the maneuver button with the arrow pointing up or down respectively.
Safety Regulations
- When the table is run up/down, maintain the necessary safety distance to avoid the risk of getting squeezed between the moving tabletop and fixed objects in the surrounding area.
- When the table is run up/down, the user must keep watch so that nobody is injured and no object is damaged. The tabletop must not bump into a fixed object so that the table is overturned. Always remove any office chair before the table is run up/down.
- When the table is left unattended, the safety key must be removed from the hand control and placed out of reach of children.
- The table tripod must not be altered or reconstructed in any way.
- Alterations to the control box are absolutely forbidden!
- The table must not be used as a hoisting device for persons.
Maintenance Features
- After approximately 1 week of use, check that the screws are properly tightened.
- If the table cannot be lowered or raised, check the connections between the legs and the wall socket, and ensure the safety key is inserted in the hand control.
- If any part of the electrical system is replaced, the electrical cable must first be disconnected from the wall socket. Replace the electrical part and then connect the electrical cable to the wall socket. The table will then be ready for use.
If the table still does not work, please contact your nearest IKEA store or customer service.
Double Insulation
SERVICING OF DOUBLE-INSULATED PRODUCT.
In a double-insulated product, two systems of insulation are provided instead of grounding. No grounding means is provided on a double-insulated product, nor is a means for grounding to be added to the product. Servicing a double-insulated product requires extreme care and knowledge of the system, and must be done only by qualified service personnel. Replacement parts for a double-insulated product must be identical to the parts they replace. A double-insulated product is marked with the words, "DOUBLE-INSULATION" or "DOUBLE INSULATED". The symbol (square within a square) can also be marked on the product.
FCC and Innovation Science and Economic Development Canada Compliance
This device complies with Part 15 of the FCC Rules and Innovation Science and Economic Development Canada's licence-exempt RSS standard(s). Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation of the device.
WARNING: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Waste Disposal
The crossed-out wheeled bin symbol indicates that the item should be disposed of separately from household waste. The item should be handed in for recycling in accordance with local environmental regulations for waste disposal. By separating a marked item from household waste, you will help reduce the volume of waste sent to incinerators or landfill and minimize any potential negative impact on human health and the environment. For more information, please contact your IKEA store.
Need help?
General
To Next Page