Let the dishes cool down before you remove
them from the appliance. Hot dishes are easi-
ly damaged.
Removing the load
• First remove items from the lower basket,
then from the upper basket.
• There can be water on the sides and door
of the appliance. Stainless steel becomes
cool more quickly than the dishes.
Care and cleaning
Warning! Switch the appliance off
before you clean the filters.
Cleaning the filters
Important! Do not use the appliance without
the filters. Make sure that the installation of
the filters is correct. Incorrect installation will
cause unsatisfactory washing results and
damage to the appliance.
1
2
A
C
B
Fully clean the filters
A, B and C below run-
ning water.
3
1
2
To remove filters B
and C, turn the han-
dle approximately
1/4 anticlockwise.
4
A
Remove the flat filter
A from the bottom of
the appliance.
5
2
1
Put the filter system
in position. To lock
the filter system, turn
the handle clockwise
until it locks in posi-
tion.
Important! Do not remove the spray arms.
If the holes in the spray arms become clog-
ged, remove remaining parts of soil with a
cocktail stick.
Long periods of non-operation
Do these steps when you do not use the ap-
pliance for a long period:
1. Disconnect the mains plug from the mains
socket.
2. Close the water tap.
3. Keep the door open to prevent unpleas-
ant smells.
4. Keep the inner side of the appliance
clean (filters especially).
External cleaning
Clean the external surfaces of the appliance
and control panel with a damp soft cloth. On-
ly use neutral detergents. Do not use abra-
sive products, scouring pads or solvents (ace-
tone, trichloroethylene etc...).
ENGLISH 15
To Next Page
Loading...
