TheSTOPbuttonclearsanyincorrectcommandandcancels
mostfunctionsexceptfortheControlLock.Itwillnoterasethe
timeofdayunlessthedisplayisinSetClockmode.See"Clock"
section.
Themicrowaveovenwillalsoturnoffwhenthedoorisopened.
ClosethedoorandtouchSTARTtoresumethecycle.
Ado; 50 S®co; c
With the SELECTOR dial turned to MANUAL, the ADD 30 SECONDS
control automatically starts the microwave oven at 100% power for
30 seconds. Each additional touch of the control will add 30 seconds
of cook time.
Cook time may be added to a manual cooking cycle at the
current power level by touching ADD 30 SECONDS.
NOTE: To avoid unintentional operation of the microwave oven,
a cooking function cannot be started if the microwave oven door
has been closed for about 5 minutes or more. "DOOR" will
appear in the display until the door is opened and closed.
Use the SELECTOR dial to enter programming modes, or
standby mode.
Use the SE-i-i-INGS dial to select options, set the clock, set cook
time and cook power, select food type and amount/weight, and
adjust doneness.
This is a standard 12-hour clock (12:00-11:59).
To Set:
1. Turn SELECTOR dial to SET CLOCK.
2. Turn SETTINGS dial to set the hour.
3. Press START.
The "minutes" digits will flash in the display.
4. Turn SETTINGS dial to set the minutes.
5. Press START to complete the setting.
6. Return SELECTOR dial to OFF position.
To Cancel Clock:
1. Turn SELECTOR dial to SET CLOCK.
The clock-setting display will show, with the hour digits
flashing.
2. Press STOR
The clock will disappear.
3. Return SELECTOR dial to OFF.
Tones are audible signals that cannot be turned off, and their
volume cannot be changed. These tones indicate the following:
One tone
• Reminder, repeat each minute after the end-of-cycle tones
Two tones
• Hidden feature has been entered or exited
Three tones
• End of cycle
• Invalid entry
Conso Lxc ck
The Control Lock shuts down the panel controls to avoid
unintended use of the microwave oven.
When the control panel is locked, none of the controls will
function. If a control is pressed, "LOC" will appear in the display
and invalid entry tones will sound.
To Lock/Unlock Control: Before locking, make sure the
microwave oven is off. Press and hold STOP for 3 seconds until
the tone sounds. Repeat to unlock the controls.
Depending on the length of the cooking cycle, the cooling fan
may continue to run after that cycle has ended. This is normal,
and helps eliminate moisture that may accumulate inside the
microwave oven before the door is opened.
While the fan is running, "COOL" will appear in the display. The
fan will turn off automatically. New cooking functions may be
started while "COOL" is still displayed.
6
To Next Page
Loading...
