IKEA IUD7500BS1 - Page 10

Connectdrainhosetowasteteeorwastedisposer
usingoneofthefollowingoptions:
, OptionA,Wastedisposer-noairgap
, OptionB,Nowastedisposer-noairgap
, OptionC,Wastedisposer-withairgap
, OptionD,Nowastedisposer-withairgap
IMPORTANT:Thedrainhoseconnectionofthedisposerora
wasteteemustbemadebeforethedraintrapandatleast
20"(50.8cm)abovethefloorwherethedishwasherwillbe
installed.
HelpfulTip:Toreducevibrationofthehose,keepthehoseaway
fromthefloor.
Option A, Waste disposer - no air gap
1. Using a hammer and screwdriver,
knock plug into disposer.
2. Use needle-nose pliers to remove
plug.
3,
Attach drain hose to disposer inlet
with large blue drain hose clamp
(provided). Use pliers to squeeze
clamp open and move into position.
Option B, No waste disposer - no air gap
1. Fit rubber end of drain hose to waste
tee and cut if needed.
NOTE: Do not cut ribbed section.
2, Attach rubber end of drain hose to
waste tee with a large blue drain
hose clamp (provided). Use pliers to
squeeze clamp open and move into
position. If the drain hose was cut,
use a 1V2" to 2" (3.8 to 5 cm) screw-
type clamp (not provided).
10