To Next Page
K
Kevin AndersonSep 7, 2025
Why does my IKEA RENGORA have unusual foam?
- JJordan MillerSep 7, 2025
If you notice unusual foam during a wash cycle in your IKEA Dishwasher, make sure you are only using detergent specifically designed for dishwashers.
Why does my IKEA RENGORA have unusual foam?
If you notice unusual foam during a wash cycle in your IKEA Dishwasher, make sure you are only using detergent specifically designed for dishwashers.
What to do if IKEA RENGORA Dishwasher programme does not start?
If the IKEA Dishwasher programme doesn't start, possible causes include: the mains plug is not connected, so connect it; the appliance door is open, so close it; the fuse in the fuse box is damaged, so replace it; or the delay start is set, so cancel the delay start or wait for the countdown to end.
How to fix IKEA RENGORA when the programme does not start?
If the IKEA Dishwasher programme isn't starting, make sure the mains plug is properly connected to the socket. Also, ensure the appliance door is fully closed. Check the fuse in the fuse box and replace it if damaged. If a delay start is set, either cancel it or wait for the countdown to finish.
What to do if my IKEA Dishwasher does not drain water?
If your IKEA Dishwasher isn't draining water, check to ensure that the sink spigot is not clogged and that the drain hose has no kinks or bends.
How to remove limescale from IKEA RENGORA?
To remove limescale deposits from the tub and inside the door of your IKEA Dishwasher, clean the appliance with cleaners specifically designed for this purpose. You might also try a different detergent.
Why are there whitish streaks on glasses from my IKEA RENGORA?
If you notice whitish streaks or bluish layers on your glasses and dishes after using your IKEA Dishwasher, it could be due to excessive rinse aid. Try adjusting the rinse aid selector to a lower setting. It may also be caused by too much detergent.
Why is the inside of my IKEA RENGORA Dishwasher wet?
The interior of your IKEA Dishwasher being wet is not a defect. It's due to humidity in the air condensing on the walls.
What to do if my IKEA Dishwasher is not filling with water?
If your IKEA Dishwasher isn't filling with water, several factors could be the cause. Ensure that the water tap is fully open and that the water supply pressure is adequate. Check if the water tap or the filter in the inlet hose is clogged, and also inspect the inlet hose for any kinks or bends.
Why salt indicator stays on in my IKEA Dishwasher?
The salt indicator in your IKEA Dishwasher might stay on after refilling the salt container if you're using salt that takes longer to dissolve. This doesn't negatively affect the appliance's performance. If the indicator remains on after 3 or 4 cycles, contact the service.
Why does the salt indicator stay on in my IKEA RENGORA?
The salt indicator in your IKEA Dishwasher might stay on after refilling the salt container if you're using salt that takes longer to dissolve. This does not negatively affect the appliance's performance. If the indicator remains on after 3 or 4 cycles, contact the service.
General| Capacity | 13 Place Settings |
|---|---|
| Number of Programs | 5 |
| Delay Start | Yes |
| Child Lock | Yes |
| Type | Built-in |
Initial setup and usage guidelines for the appliance.
How to set water hardness for optimal water softener performance.
Instructions on how to fill the salt reservoir to prevent limescale.
Guide to filling the rinse aid dispenser for better drying.
Instructions for filling the detergent dispenser correctly.
Overview of the appliance's control panel buttons and indicators.
Explanation of the automatic door opening system for drying.
Guidance on placing delicate items in the upper basket.
How to adjust folding racks for optimal dish placement.
Guidance on placing pots and larger items in the lower basket.
Proper placement of cutlery in the basket for effective cleaning.
How to adjust the height of the upper basket for different loads.
Common issues and solutions for appliance problems.
