Why does my IKEA RENGORA Dishwasher keep tripping the circuit breaker?
If your IKEA Dishwasher is tripping the circuit-breaker, it may be due to insufficient amperage to supply all appliances in use simultaneously. Check the socket amperage and meter capacity, or turn off another appliance. If this doesn't solve the problem, it could indicate an internal electrical fault, and you should contact an Authorised Service Centre.
Why is my IKEA RENGORA Dishwasher door hard to close?
If the door of your IKEA Dishwasher is hard to close, ensure the appliance is level by adjusting the feet. Also, check if any tableware is protruding from the baskets, obstructing the door.
Why does my IKEA RENGORA keep stopping and starting?
The IKEA Dishwasher stopping and starting multiple times during operation is normal. This behavior ensures optimal cleaning and energy savings.
Why is the inside of my IKEA RENGORA Dishwasher wet?
The interior of your IKEA Dishwasher being wet is not a defect. It's due to humidity in the air condensing on the walls.
What to do if my IKEA Dishwasher is not filling with water?
If your IKEA Dishwasher isn't filling with water, several factors could be the cause. Ensure that the water tap is fully open and that the water supply pressure is adequate. Check if the water tap or the filter in the inlet hose is clogged, and also inspect the inlet hose for any kinks or bends.
Why is my IKEA Dishwasher door not closing?
If you're having trouble closing the door of your IKEA Dishwasher, ensure that the left and right rails of the upper basket are positioned at the same height.
What to do if my IKEA Dishwasher has poor drying results?
If your IKEA Dishwasher isn't drying dishes well, consider these points: * Avoid leaving tableware inside the closed appliance for extended periods. * Ensure the rinse aid dispenser is filled and set to an appropriate level. * Be aware that plastic items may require towel drying even after a cycle. It's recommended to consistently use rinse aid, even when using multi-tablets.
What to do if my IKEA Dishwasher won't start the program?
If your IKEA Dishwasher program isn't starting, make sure the appliance door is fully closed. Also, check if the delay start function is activated; either cancel the setting or wait for the countdown to finish.
What to do if my IKEA Dishwasher anti-flood device is on?
If the anti-flood device on your IKEA Dishwasher is activated (indicated by the end indicator flashing 3 times and the drain pump running continuously), immediately close the water tap.
Why is my IKEA RENGORA not activating?
If your IKEA Dishwasher isn't activating, first ensure that the mains plug is securely connected to the mains socket. Also, check your fuse box for any damaged fuses.
General| Capacity | 13 Place Settings |
|---|---|
| Number of Programs | 5 |
| Delay Start | Yes |
| Child Lock | Yes |
| Type | Built-in |
Initial setup and usage guidelines for the appliance.
How to set water hardness for optimal water softener performance.
Instructions on how to fill the salt reservoir to prevent limescale.
Guide to filling the rinse aid dispenser for better drying.
Instructions for filling the detergent dispenser correctly.
Overview of the appliance's control panel buttons and indicators.
Explanation of the automatic door opening system for drying.
Guidance on placing delicate items in the upper basket.
How to adjust folding racks for optimal dish placement.
Guidance on placing pots and larger items in the lower basket.
Proper placement of cutlery in the basket for effective cleaning.
How to adjust the height of the upper basket for different loads.
Common issues and solutions for appliance problems.
To Next Page
