9
ENGLISH
Product description
Upper chimney
Lower chimney
Hood body
LED Lighting
Grease filter
Control panel
Control Panel
S0614 (170201)
backlight symbols
112
20 20 20 20
8
S0614 (170201)
backlight symbols
Speed
Turns the motor on/o at speed one.
Attention: the product is with the lter alarm disabled.
Press and hold the button for approximately 2 seconds, with all the loads turned o (Motor+Lights), to turn the grease lter alarm on. LED
(B) ashes twice to conrm.
To turn the alarm o, press the button again and hold for at least 2 seconds. The relevant LED (B) ashes once.
Speed
Turns the motor on at speed two / Activate charcoal lter alarm.
Attention: the product is with the lter alarm disabled.
Press and hold the button for approximately 2 seconds, with all the loads turned o (Motor+Lights), to turn the Activated Charcoal Filter
alarm on. LED (A) ashes twice to conrm.
To turn the alarm o, press the button again and hold for at least 2 seconds.The relevant LED ashes once (A). Only for recirculation mode.
Speed
Turns the Motor on at speed three / Reset alarm lter saturation.
Press and hold the button for approximately 2 seconds, with all the loads turned o (Motor+Lights), to reset the grease lter
saturation alarm or charcoal lter alarm. LED (A) ashes three times.
Speed
Turns the motor on at Booster speed.
This speed is timed to run for 6 minutes. At the end of this time, the system returns automatically to the speed that was set before. If it is
activated with the motor turned o, it will switch to OFF at the end of the time. To deactivate it, press button D or press button A.
Light
Press briey: Turns the lighting system on and o at maximum intensity.
Press and hold to change the lighting intensity up or down.