Warning! Danger of
electrocution! Disconnect the fuse
before you replace the lamp.
The lamp and the lamp glass
cover can be hot.
1. Turn o the oven.
2. Remove the fuses from the fuse box or
turn o the circuit breaker.
3. Turn the lamp glass cover
counterclockwise to remove it.
4. Clean the glass cover.
5. Replace the oven light bulb with a 25 W,
230 V (50 Hz), 300 °C heat resistant oven
light bulb (connection type: E14).
6. Install the glass cover.
Troubleshooting
Warning! Refer to Safety
chapters.
What to do if...
Problem Possible cause Remedy
The oven does not heat up. The oven is deactivated. Activate the oven.
The oven does not heat up. The fuse is blown. Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again and
again, contact a qualied
electrician.
The lamp does not operate. The lamp is defective. Replace the lamp.
Steam and condensation set‐
tle on the food and in the
cavity of the oven.
You left the dish in the oven
for too long.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.
The lamp is turned o. The ECO Cooking function is
turned on.
Normal behaviour of the ECO
Cooking function. Refer to
"Daily Use" chapter, Heating
Functions.
Service data
If you cannot nd a solution to the problem
yourself, contact an Authorised Service
Centre.
The necessary data for the service centre is
on the rating plate. The rating plate is on the
front frame of the oven cavity. Do not
remove the rating plate from the oven cavity.
We recommend that you write the data here:
Model (MOD.) .........................................
Product number (PNC) .........................................
ENGLISH 18
To Next Page
Loading...
