up, and the safety device switches o. If
you do not push the knob, the gas supply
is interrupted.
3. When you light the ame, you can adjust
it.
If the burner does not ignite, after
a few attempts, check if the crown
and its cap are in correct
positions.
1
Burner cap
2
Burner crown
3
Ignition candle
4
Injector
5
Thermocouple
Warning! Do not keep the control
knob pressed for more than 15
seconds. If the burner does not
light after 15 seconds, release the
control knob, turn it into o
position and wait for at least 1
minute before trying to light the
burner again.
If there is no electricity, you can
ignite the burner without an
electrical device. In this case,
approach the burner with ame,
push the relevant knob and turn it
anticlockwise to the maximum
gas release position.
Warning! Be careful when you
use open re in the kitchen
environment. The manufacturer
declines any responsibility in case
of misusing the ame.
If the burner accidentally goes
out, turn the control knob to the
o position and wait for at least 1
minute before trying to light it
again.
When you switch on the mains
after installation or a power cut,
the spark generator activates
automatically.
The hob is supplied with the
progressive valves. They make the
ame regulation more precise.
Turning the burner o
To put the ame out, turn the relevant
control knob clockwise to the symbol .
Warning! Always turn the ame
down or switch it o before you
remove the pans from the burner.
Hints and tips
Warning! Refer to Safety
chapters.
Diameters of cookware
Keep the cookware centered on
the pan supports.
Use pots and pans with bottom
tting the size of burner used.
Burner
Minimum di‐
ameter of
pots and pans
Maximum di‐
ameter of pots
and pans
Rapid 180 260
ENGLISH 12
To Next Page
Loading...
