5019 618 33123
PRODUCT SHEET
1. Control panel.
2. Grease filter
(1 or 2 pieces depending on model).
3. Grease filter spring release handles.
4. Lighting unit.
5. Pull-out steam deflector.
6. Extractor unit body.
Grease filters:
Metal grease filters have an unlimited life and should be
washed once a month either by hand or in a dishwasher at a
low temperature and with a short cycle. Washing in a
dishwasher can cause grease filters to turn white, but this in
no way affects efficiency.
Removing and/or washing the grease filter/s
1. Disconnect the electrical power supply.
2. Remove the dirty grease filter/s by pulling the handle first
backwards and then downwards (Fig. 1).
3. After cleaning the grease filter, refit in reverse order,
making sure the entire extraction surface is covered.
Replacing bulbs
1. Disconnect the electrical power supply.
WARNING: Wear gloves.
2. Use a small screwdriver or any other suitable tool to prise
off the lamp cover (Fig. 2).
3. Remove the burnt-out bulb.
4. Replace using 40 W max E14 bulbs only.
5. Replace the lamp cover so that it clicks into position.
Fitting or replacing the carbon filter
(filter hoods only).
Change the carbon filter every four months. The filter cannot
be washed or regenerated.
1. Disconnect the electrical power supply.
2. Remove the grease filter/s (Fig. 1).
3. If the carbon filters are already mounted (one or two
filters, depending on the model. covering the motor
protection grille) and need renewing, turn the central
handle (Fig. 3 - c) anticlockwise until the filters release.
4. If the carbon filters are not already mounted, locate the
filters to cover the motor protection grilles (two
protection grilles - two carbon filters, one protection grille
- one carbon filter), then turn the central handle
(Fig. 3 - c) of the filters clockwise.
5. Refit the grease filter/s (Fig. 1).
CONTROL PANEL
Light switch.
The switch has two positions (lights OFF - lights ON).
To switch on the lights: move the switch to the right.
Motor switch.
The extraction speed switch has 3 settings, depending on
the amount of steam and fumes.
To increase the extraction speed: move the switch to the
right.
Fig.1
Fig.2
Fig.3
IFINNL P GR
E
S
N
DK
D
F
GB
CZ SK H
PL
RUS
BG
RO
To Next Page
Loading...
Need help?
General
