ENGLISH 8
IMPORTANT: perform maintenance of
fi lters periodically as described on relevant
paragraph.
Grease fi lter
Clean the grease fi lter once a month.
1. Disconnect the electrical power supply.
2. Remove the grease fi lters
a - push the handles backwards
b - and then downwards.
3. After cleaning the grease fi lter refi t in
reverse order, making sure the entire
extraction surface is covered.
Fitting or replacing charcoal fi lter
Charcoal fi lter is neither lavable nor
regenerable.
Replace it every 4 months.
1. Disconnect the hood from the electric
power supply.
2. Remove the grease fi lter.
3. Fit the fi lters over the motor: make sure
the pins on the manifold match the slots,
then turn clockwise until locked.
4. Carry out in the reverse order to remove.
5. Refi t the grease fi lter.
Replacing the Halogen lamps
WARNING: - Only use 20W MAX - G4
halogen lamps.
1. Disconnect the hood from the electric
power supply.
2. Insert the blade of a small fl at
screwdriver where indicated by the
three points, and with a gentle pressure
remove the light cover from its position.
3. Remove the faulty lamp and replace
with a new one.
4. Replace the cover (spring lock system).
IMPORTANT: make sure you don’t touch the
lamp with your hands.
To Next Page
