IKEA MITTZON - Handset Operation Instructions; Adjusting Table Height; Locking and Unlocking; Setting Memory Positions

5
Collision detection
• The system is designed to avoid possible damages to equipment due to collision. When the desk detects a sudden change in resistance, it will stop the
movement and move in the reverse direction by approximately 30 mm-50 mm (depends on the movement speed, collision force and the load during collision).
Handset operation instructions:
Function and status Operating Buttons Operation method Button press
duration time
Light colour Light
display
eect
Note
Up Up button Long press / No light / /
Down Down button Long press / No light / /
Locking Up button+Down
button
Long press together 3 sec Red light Blinks 1. After the locking setting is complete, the red light
blinks twice and then turns o.
2. No light is displayed when the unit is locked.
3. In the locked position, press any button and the red
light will blink 1 time to indicate the locked status.
Unlocking Up button+Down
button
Long press together 3 sec Green light Blinks 1. After the unlocking setting is complete, the green light
blinks twice and then turns o.
2. No light is displayed during unlocking.
Set memory position 1 Memory 1 button Long press 3 sec White light Blinks 1. After the setting is complete, the white light blinks
twice and then turns o.
2. No light is displayed during the setting.
Set memory position 2 Memory 2 button Long press 3 sec White light Blinks 1. After the setting is complete, the white light blinks
twice and then turns o.
2. No light is displayed during the setting.
Memory 1 position Memory 1 button / One click No light / Please ensure there are no obstacles under or above the
table before Memory 1 position is set.
Memory 2 position Memory 2 button One click / No light / Please ensure there are no obstacles under or above the
table before Memory 2 position is set.
Reset Pin hole +Down button 1 click the pin-hole
rst, then long
press down button
/ Orange light Steady on First, poke the pinhole at the bottom of the hand
controller with a pin to enter the reset status (at this
time, the orange light will be steady on), and then long
press the down button until the table goes down to the
lowest height, and then raise it up 7 mm automatically
to complete the reset. After the reset is successful, the
orange light will turn o.
Abnormal error status Pin hole +Down button Reset operation / Orange light Blinks In the abnormal status, the orange light continues to
blink. Pressing any button does not work. You need to
check if all the cables are properly connected, and then
perform the reset.
Overheat protection
status
/ Rest for approx.
18 minutes
before continuing
operation of unit
/ Blue light Steady on This is not an abnormal error status, but due to the
motor working continuously, overheat protection may
activate. After approx. 18 minutes of rest, the blue light
will turn o and normal operation can be resumed.