20
EN
BEFORE YOU CALL
Cooktop Problems
Problem Cause / Solution
The number in the setting
indicator is fl ashing.
Incorrect cookware used. See “Using Proper Cookware” on page 9.
Cookware is the wrong size or incorrectly positioned in the cooking zone. See
“Pan Sensing” on page 10.
The letter E appears in a
setting indicator
An error has occurred. This may happen because cookware has boiled dry.
Remove cookware and turn off the cooktop. After 30 seconds, turn on the
cooktop. If the cookware was the problem, E will no longer display.
An error may occur because of water, oil, or food on the controls. Clean the
control panel.
Disconnect the power to the cooktop for a minute, then reconnect it. If the
error still occurs, call an authorized dealer or service technician.
The letter L appears in the
setting indicators.
The cooktop is locked. See “Lock or Unlock the Cooktop” on page 15.
The cooktop deactivates
A signal sounds when the
cooktop is not operating
There is an object on the controls. Remove the object. See “Key-Stuck Func-
tion” on page 16.
The Hot Cooktop warning
did not come on
The cooktop did not get hot enough to activate the warning.
If the cooktop was running long enough for the surface to get hot, call an
authorized dealer or service technician.
The control area becomes
hot
The cookware is too large or too close to the controls. Put large cookware on
a rear zone if possible.
A dash (-) shows in the
setting indicator
This zone cannot be used until the cooktop is turned off, then turned on. The
other zones are still operable.
To Next Page
Loading...
