6
Auto mode
In Auto mode, the product selects
the fan speed in accordance with the
ambient air quality.
The air quality sensor is active and
measures PM 2.5 particles when the air
purier is running.
Only in the IKEA Home smart app.
Indicators for air quality (PM 2.5):
Green: 0-35 / Good
Amber: 36-85 / OK
Red: 86- / Not good
• Operational temperature:
0°C to 40°C (32°F to 104°F).
• Humidity when operational:
10 to 60% RH
(Recommended operational humidity:
40-60% RH)
When STARKVIND air purier is
connected to the mains for the rst
time, the LED lights on the control panel
light up in succession. When the LED
lights stop illuminating, the product is
ready to use.
Press the control knob to put it in Auto
mode, or turn to the desired level. Press
the knob again to turn it o.
A long press activates the Control lock.
It can also be controlled from the app
IKEA Home smart.
Care instructions
Unplug the product before cleaning.
To clean the product, wipe with a soft
damp cloth. Use another soft dry cloth
to wipe dry.
Vacuum clean the pre-lter regularly.
Note!
Never use abrasive cleaners or chemical
solvents since these can damage the
product.
Cleaning the air quality sensor
Vacuum clean the air quality sensor
regularly.
Filter replacement
When replacing the lter, it is essential
that the user proceeds as follows:
One LED light illuminated on the control
panel indicates that you should check
your lters.
1
AUTO
2
3
4
5
Warning!
The power supply cord must be
disconnected during lter replacement!
1. Disconnect the power and wait until
the fan has stopped.
2. Remove the pre-lter and clean the
pre-lter with a vacuum cleaner or
with water depending on how dirty
it is.
3. Remove lter(s), and handle used
lters carefully. Dispose of the
lter(s) in accordance with local
environmental regulations for waste
disposal.
4. Clean the inside, removing all dust
and dirt.
To Next Page
Loading...
Need help?
General
