REMOTE CONTROL FUNCTIONS
ON/OFF: Press to turn your light
source on and off.
Press and hold for at least 3 seconds
to synchronize your lights.
Dim up/down: Short presses will
dim up/down in steps. To dim up/down
seamlessly, press and hold the button.
Change white spectrum, colours or
scenes.
Pairing: Add IKEA Smart Lighting
products to your system. See
instructions below.
ADDING DEVICES TO YOUR
REMOTE CONTROL
When the remote control is sold together
with a light source (in the same package),
they are already paired. If the remote
control is purchased separately, you must
manually pair it to your light source.
To add light sources, just repeat the steps
below.
1. Make sure that your light source is
installed and the main power switch is
turned on.
2. Hold the remote control close to the
light source you want to add (no more
than 5 cm away).
3. Press and hold the pairing button
for at least 10 seconds. A red light will
shine steadily on the remote control.
Your light source will begin to dim and
ash one time to indicate that it has
been successfully paired.
Up to 10 light sources can be paired with 1
remote control.
Make sure to pair them one at a time. If
the light sources are close to each other,
disconnect those that have already been
paired from the main power switch.
ENGLISH 4
To Next Page
Loading...
