Never use a damage or faulty USB cable for charging, since this can damage the appliance and
harm your device.
TECHNICAL DATA
Type: E1746 wireless Signal Repeater
Input: 5.0V DC
Range: 10 m in open air
For indoor use only
Operating frequency: 2405-2480Mhz
Output power: 3 dBm
Instructions for use
Connect the power adapter into the wall socket, insert the Signal Repeater into the free slot.
When charging only use a recommended USB cable for your device and replace faulty cables
imminently.
Good to know
Can be used to charge the wireless roller blind battery cell.
USB cable length and quality influence charging speed and performance.
Devices may get warm during charging; this is completely normal and they will gradually cool
down again after they are fully charged.
Storage temperature: -20°C to 25°C (4°F to 77°F).
Operating temperature: 0°C to 40°C (32°F to 104°F).
Unplug the power adapter from the
power source before cleaning and when it is not in use.
Recommended precautionary measures and technical data, see the back of the power adapter.
CARE INSTRUCTIONS
To clean the Signal Repeater and the Power Adapter wipe with a soft dry cloth.
NOTE!
Never use abrasive cleaners or chemical solvents as this can damage the product.
Save these instructions for
future use.
Product servicing
Do not attempt to repair this product yourself, as opening or removing covers may expose you to
dangerous voltage points or other risks.
TECHNICAL DATA
Type: ICPSW5-5NA-1
Input: 100-240VAC, 0.2A, 7.0W
Output: 5.0V DC, 1.0A, 5.0W
Indoor use only
Max total load: 1.0A
Manufacturer: IKEA of Sweden AB
Address:
Box 702, SE-343 81 Älmhult, SWEDEN
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation Science and
Economic Development Canada’s license-exempt RSS standard(s).
Operation is subject to the following two conditions:
1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause
To Next Page
Loading...
