EasyManua.ls Logo

IKEA tradfri - Material-Specific Fittings; Choosing Correct Fixtures

IKEA tradfri
5 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Design and Quality
IKEA of Sweden
Contents [ hide
1 WIRELESS SIGNAL REPEATER FUNCTIONS
2 IMPORTANT!
3 Related Manuals:
WIRELESS SIGNAL REPEATER FUNCTIONS
With TRÅDFRI signal repeater you can expand the signal reach of your IKEA Home smart products.
Pairing: Add IKEA Home smart products to your system. See instructions below.
ADDING STEERING DEVICE TO YOUR SIGNAL REPEATER
When the Signal Repeater is sold together with another IKEA Home smart product (in the same
package), they are already paired.
You cannot add IKEA Home smart products directly to your signal repeater. A TRÅDFRI steering device
is needed to add them.
To add steering devices, just follow the steps below:
Make sure that your signal repeater is plugged in and the main power is turned on.
1. Hold the steering device close to the signal repeater you want to add (no more than 5 cm away).
2. Press and hold the pairing button for at least 10 seconds, you can find the pairing button under
the rear cover.
3. A red light will shine steadily on the steering device.
Then go to the product you want to steer and then repeat the pairing.
On your IKEA Home smart products, a white light will begin to dim and flash one time to indicate that
it has been successfully paired.
FACTORY RESET YOUR DEVICE
For wireless signal repeater:
Push a pin into the pinhole on bottom of the signal repeater for at least 5 seconds.
After reset the signal repeater you must pair your steering device to the signal repeater and then pair
the steering device to your IKEA Home smart product again.
IMPORTANT!
The Signal Repeater is for indoor use only and can be used in temperatures ranging from 0ºC to
40 ºC (32ºF to 104 ºF).
Do not leave the wireless Signal Repeater in direct sunlight or near any heat source, as it may
overheat.
The range between the wireless Signal Repeater and the receiver are measured in the open air.
Different building materials and placement of the units can affect the wireless connectivity range.
WARNING:
The wall socket must be located near the equipment and must be easily accessible.
Only use in dry locations.
Children should be supervised to ensure they do not play with the product.
If the device is damaged it shall be destroyed.

Other manuals for IKEA tradfri

Related product manuals