IKEA UPPLEVA 24" - Page 12

11
Advanced), then congure proper
cable information as described
below. Use the digit buttons to
adjust the values of frequency,
symbol rate and network ID; use /
to select a modulation mode.
Press • OK to start initial setup
relating to all DVB-C digital and
analog channels.
Note: To prevent the channel setup
process from being interrupted, wait for
the message indicating that the setup is
complete.
Before starting the scanning, you can 4.
also select Skip Scan to skip the initial
setup process.
During the setup, you can follow the 5.
hints available at the bottom of the
screen to return to the previous step by
pressing BACK. Or press EXIT to exit or
interrupt the search halfway.
Once the automatic search ends, the set 6.
enters the next step automatically. You
can press / to select your location
Shop or Home. Press OK/ to conrm
your selection and enter the last step.
7.
In this step, you can press  OK to
exit the initial setup. The channels
are arranged in a preset order. If
you wish to skip channels, modify
the preset order or rename channels,
select SETUP > Organiser and press
OK/ to enter.
In this step, you can also press  BACK
to return to the previous step.
Automatically install channels
This section describes how to search and
store channels automatically. Instructions
are for both analog and digital channels.
Press 1. MENU on the remote control and
select SETUP > Language > Menu
Language. Press / to select your
desired menu language.
Press 2. BACK to return to SETUP, press
/ to select Country, then press /
to select your country. The TV installs
and arranges channels according to your
country.
Press 3. / to select Tuner Mode, then
press / to select Air or Cable.
Select  Air.
Press • / to select Channel
Install, and press OK/ to enter.
Select • Automatic Search (Refer
to Figure 2.), then press OK/ to
display Automatic Search.
Press • OK to skip the country
selection and enter the next step.
Or use / to reselect your country,
then press OK to enter.
Select • Digital & Analog, Digital or
Analog, then press OK/ to start
the automatic search, which relates
to all DVB-T digital and/or analog
channels.
Select  Cable.
Press • / to select Channel
Install, and press OK/ to enter.
Select • Automatic Search, then
press OK/ to display Automatic
Search.
Press • OK to skip the country
selection and enter the next step.
Or use / to reselect your country,
then press OK to enter.
•
Select  Digital & Analog, then
press OK/ to enter. Select your
scan mode if available and congure
proper cable information in the
same way as in initial setup. Select
Scan and press OK/ to start your
automatic search relating to all
DVB-C digital and analog channels.
Select  Digital, then follow the
same process as above to start
your automatic search relating to all
DVB-C digital channels.
Select  Analog, then press OK/ to
start your automatic search relating
to all analog channels.
The search may take a few minutes. 4.
During the process, you can press EXIT
to abort halfway.
Once the automatic search ends, press 5.
BACK to return to the previous step or
press OK to restart your channel search.
After the automatic search, channels are 6.
arranged in a preset order. You can skip
channels, modify the preset order or
rename channels.