Ikegami CMF-1580 - Using the Auto-Skip Mode

Eng-13
Using the Auto-Skip Mode
When the Auto-skip options is set in the MENU settings, and no input signals are
found for the channels 2, 4 and VCR, the Monitor will operate as follows:
After 1 second After 1 second After 1 second
(After scanning 4 channels)
Camera 2 Scanning
No Input Signal
Camera 3 Scanning
Camera 4 Scanning
No Input Signal
Camera 1 Scanning
After 1 second After 1 second After 1 second
(After scanning 4 channels)
Camera 2 Scanning
No Input Signal
Camera 3 Scanning
Camera 4 Scanning
No Input Signal
Camera 1 Scanning
(After auto-timer duration) (After auto-timer duration)
(After auto-timer duration)
Camera 1 Camera 3
Camera 1
Camera 3