Ikegami TM20-20RH - Installation; 4-1. Connection with External Equipment; 4-2. Parallel Remote Connector Connection Procedure

4. INSTALLATION
4-1. Connection with External Equipment
· Input RGB or YPBPR signals here. Refer to
Section· 5-6.(5) for details on switching
between RGB and
YPnPit.
· When not looping through, conllect the
optional terminator plug.
· With the optional Dual Component board
(DC 301), two inputs (single end) can be
used.
AUX
INPUT
e~e
0
G/Y
0~0
REMOTE
· Plug in the remote connector
· See 4-2 for the pin connections.
4-2. Parallel Remote Connector Connection Procedure
(Notes)
· Input composite video signals here.
· When not looping through , connect the
optional terminator plug.
· When using the optional _ Y/C input, CH C
can not be monitored. Refer to Sect ion 5-6.(5)
for
details on switching between Y /C and CH
C.
VIDEO
INPUT
0 ~0
0 ~0
0 ~
0~
· Input the video input and AUX input
external sync signals here.
· When not looping through, connect the
optional terminator plug.
From the program version 2.1 (displayed on the upper right of the MENU 1 screen), PARALLEL/REMOTE functions are
changed as follows:
(1) Functional changes
Pin No.5: SYNC INT (GND)
/EXT~ DIGITAL ON (GND) /OFF
Pin No.8 :
V (GND) /VS ~ 16 : 9 (GND) I 4 : 3
(2) While in the old version, front panel switches related to those on the remote side are disabled when thelREMOTElswitch
is ON, from version 2.1, the front panel switches are operable when those on the remote side are in opening condition.
(3) SYNC INT/EXT and V / VS are automatically switched to their preset status when input channels are switched.
- 10 -
,-_··--1
..
,-)
J
J
J
J
J