[:
r·-
[.
[_.
I __ :
l '.
u
L
I :
1.·
! ;,
@!ROTATION! Switch
This switch corrects the purity from the influence of
geomagnetis m after the monitor
has been rot ated.
Th e operation procedure is the same
as for ®· Th e
adjustment method is explained in 5-4.(4).
When using the monitor in
a situlition where it is
constant ly changing its direction , for example in
a
relay vehicle, set the L bit connector on the DEF
board "OFF " so the !ROTATIO N! switch goes not
work. The monitor is shipped from the factor with
this connector set "ON".
Left side surface
DEF BOARD
\
@!FINE FOCUSISwitch
· This is the switch for fine adjustmen t of the focus.
Th e operation procedure is the same
as for ®· The
adjustmen t method is explained in 5-4.(3).
@IWIDTHI Switch
This switch adjusts the width of the effective screen.
The operati on procedure
is the same as for ®· Since
the memories concerning the WIDTH dat a are
provided for three kinds of size (16:9 under, 4:3 under and 4:3
normal scan respectively) changed by the
~
switch on the
front panel, set this data linked with the
~
switch.
For concrete details of the operation, see 5-5.(1),
Example
1.
®I HEICHTjSwitch
This switch adjusts the height of the effective screen.
The operat ion procedure is the same
as for ®· The
same as for th e
!WIDTH! switch @, ther e is memory
for height data for thr ee types of scanning size.
For concrete details of the operat ion, see 5-5.(1),
Example
1.
® IH. PHASEISwitch
This switch adjusts th e video horizontal phase . The
operation procedure is the
s·ame as for ®· You can
select whether to use th e same H.PHASE for all the
channels or set it separat ely for each channel. (See
5-
6. (6).)
If you set the same H. PHASE for all channels and
outp ut the 100% safe title frame, then you can
visually check
phase displacement of video signals.
If you set the H.PHASE separately for each channel,
then you can set the picture at the center of the
screen for all chan nels. For details of the adjustment
method, see 5-4.(8).
®IAPTIPRESET Switch
This switch adjusts the apertur e. This switch does
not work unless you have already set the
!APT! switch
on the front panel "ON"(and switched
"ON" its LED).
The operation procedure
is the same as for ®·
@IR. BACKGROUND!Switch
This switch adjusts the low light white balance. The
operation procedure is the same as for
®· For details
of the adjustment method , see
5-4.(1).
@IC. BACKGROUND! Switch
Same as switch @.
@)IB. BACKCROUNDISwitch
Same as switch @.
@IC. GAIN! Switch
This switch adjusts the high light white balance . The
operation procedure
is the same as for ®· For details
of the adjustme nt method, see 5-4.(1).
@IB. CAIN!Swltch
Sa.me as switch ®·
- 23 -
To Next Page
Loading...
