Ikegami TM20-20RH - 5-7. Messages Displayed on the Screen

,--
r
r ·
r.··.·
{ '
i· <
\_ :
{
L
5-7. Messages Displayed on the Screen
ALL LOCK
PRESET
& FILE LOCK
CHANGE PRESET -> ON
CHANGE PRESET
-> OFF
DELAY -> OFF
APT
-+ ON
DELAY
PAL-, S-PAL
STORE
FILE_. OFF
REMOTE
SELECT-> OFF
MANUAL
-> PRESET
This message
is displayed when the /CHANGE PRESET !
/STORE FILE / , or /FILE 11 to /FILE 3/ switches are pressed, or
when changing the data using MENU, when the LOCK mode
setting (Refer to Section 5-6.(8))
is on "ALL LOCK" state .
Operate after changing the LOCK mode to "UNLOCK".
This message is displayed when the /CHANGE
PRESET / or
/STORE FILE ! switches are pressed, when the LOCK mode setting
(Refer to Section 5-6.(8)) ·is on "PRESET
& FILE LOCK" state.
This message is displayed
when each PRESET switch is pressed
(Refer to Fig. 5-3-3,4
@-@), when the /CHANGE PRESET/ switch
is "OFF".
Operate after turning the /CHANGE
PRESET/ switch "ON".
This message is displayed when the /STORE FILE! , and /FILE
1j to
/FILE 3/ switches are pressed when the /CHANGE PRESET / switch
is "ON".
Operate after turning th e /CHANGE
PRESET / switch "OFF".
This message is displayed when the !BRIGHT ! PRESET switch is
pressed in th e DELAY state.
Operate after canceling the delay state .
The brightn ess for the delay state
is adjusted with Menu Item 2.
This message is displayed when the
/APT / PRESET switch is
pressed, when the
/APT/ switch is "OFF".
Operate after turning the
/APT! switch "ON".
* This message is only displayed during the P AL-B operation.
This message is displayed when
the /HUE! PRESET and /HUE! manual
control switches are pressed, when the S-P AL switch is "OFF" .
Operate after turning the S-P AL switch "ON".
This message is displayed when the /CHANGE
PRESET / switch is
pressed, when the
/FILE 1/ to /FILE 3/ are blinking, by pressing
the
/STORE FILE/ switch.
Operate after pressing the /STORE FILE! switch and
/FILE 1j to
/FILE 31 stop blinking.
This message is displayed when the
/MENU! switch is pressed in
the REMOTE select screen (Refer to Fig. 5-3-5).
Operate after leaving the REMOTE select screen.
This message
is displayed when the optional AUTO SET UP
PROBE
(ASP-15) is connected, when any MANUAL controls are
the "MANUAL" state, or when selecting the PAL DECODE R, the
!HUE/ manual control is the "MANUAL" state.
Operate after canceling the "MANUAL" state.
- 47 -