CAN'T USE CHANGE PRESET
This message is displayed when the !CHANGE
PRESET! switch is
pressed, in the MENU operation STATUS screen (Section 5-6.(7)).
Operate after leaving the menu by pressing theiESC lswitch
. .
MODE --+ VARIABLE
This message is
displayed when the
"VARIABLE PHASE"
is
selected, in the "REFERENCE MODE" when the MENU operation
is SAFE TITLE or SPLIT screen (Section 5-6.(1), (2)).
NO SLOT .... DECODER
This message is displayed when the MENU operation is AUTO
SELECT, when decode format is
selected,
but
there
is no
DECODER board installed to handle the operation.
For examp le, when NTSC signals are being monitor ed, install a
NTSC DECODER board (SLOT section, Refer to 7.), and set the
AUTO SELECT setting on "NTSC".
NO SLOT DECODER
This message is displayed when the decoder board corresponded to
the input signal is not equipped, when you set to the "AUTO" mode
in the AUTO SELECT setting of the MENU operation.
ENTER CORRECT PASSWORD
This message is displayed when an error
is made in PASSWORD
input, when the MENU operation is set in the LOCK mode.
Input the PASSWORD correctly.
NO OPERATION It
is wrong operation.
Operate exactly.
NO SYNC This message is displayed when the
!SYNC EXT! switch is
"ON",
when ther e is no synchronized signal with the input signal, or there is
no external signal
being input .
Input an external
synchronized signal, and turn
the
!SYNC EXTI
switch "ON".
MIN
This message is displayed when the data value is minimum, when
LEVEL DISPLA Y(see section 5-6. (6)) state is "OFF" ..
MAX This message
is displayed when the data value is maximum , when
LEVEL DISPLA Y(see section 5-6. ( 6)) state
is "OFF" ..
- 48 -
'
-_.1 __ ·
. ·J
]
-.·.--)
"
·,,
]
''
-·.··)
~::i
''
. --
..<1
, '
',:..:J
''\
.,J
u
; l
~J
: :.·1
:::-
•, '
i]
u
To Next Page
Loading...
