6-7. Dual Component Modules (DC301)
(1) Summary
Adding this function makes it possible to set 2-
channel AUX input.
(2) Features
Each loop-through connector on the rear surface
AUX I_NPUT section is
a single end, the left and
right connectors are set to CH A and CH B, so
they
can be switched from the front panel.
AUX
INPUT
[[]JR/P, [l[]]
0-0
0~®
~B/Pe
~-· 0
6-8. Rack Mount Adaptor
(1) Summary
Installing the rack mount adaptor makes it possible
to hold
a monitor with an EIA standard 19-inch
rack unit.
(2) Installation method
The adaptor is installed according to the attached
drawings below.
TM14-20 K4-950053
TM20-20/30 K4-950052
6-9. Terminate Plug (TP301)
Connect ther terminate plug when loop-through is
. not being used.
6-10. Service Manual
Main contents :
· Maintenance adjustments
· Schematic Diagram
· Parts
List
6-11 SERIAL REMOTE CONTROLLER (SRC-301)
(1) Summary
One SRC-301 can centrally control up to 99 units of moni-
tors (17 /18/20/30 series color monitors) which are set with
numbers.
(2) Features
1) Control with BNC coaxial cable
As a coaxial cable is used for control, monitors can be
centrally controlled only by serially connecting them
(loop-through connectors).
2) Individual control of monitors (up to 99 units)
Setting monitors (17 /18/20/30 series) that are serially
remote controllable with numbers from 1 to 99, each one
of these monitors can be individually controlled.
3) Control items
In addition to items described
in 6-6 RCT20A (excluding
R.G SCREEN), 4:3/16:9, NORMAL/UNDER scan can
be controlled.
(3) Configuration
8-ni i¥='=ll
ma:•tACm C(llfflOlUl li=Y
SRC-301
- 52 -
l ___ ·.·.
':J
]
]
:·:i
··.··1
I
.:.cl
, '
'l
.J
: )
: _)
•• J
To Next Page
Loading...
