iKeyp Bolt - Change User Access Code

Change User Access Code
If using the iKeyp Bolt in either Connected or Offline Mode you should change the
factory default user access code to ensure it cannot be used to gain unauthorized
access. Follow these steps at any time to set a new user access code:
Enter the current user access code on the keypad to unlock the main compartment door.
You may also use a Backup Key to unlock the door.
If the combination is accepted, the iKeyp will beep and the “Status” LED will flash solid green
three times, otherwise the LED will flash red three times, and you must close the main door
and then repeat steps 1 through 3.
Solo Technology Holdings, LLC
Purchase, NY 10577
United States of America
iKeyp.com
+1 (800) 485-8904
1. With the main door open, press and hold the “ENT” key until the iKeyp beeps.
2. Enter any 4-8 digit key length combination on the keypad then press the “ENT” key. The
iKeyp will beep and the “Status” LED will flash yellow three times and then turn solid.
3. Re-enter the same combination again and then press “ENT” key to confirm the new user
access code.
5
IMPORTANT: The default kepad sequence to open the safe door is 1-2-3-4-ENT.