GB-9
RECTIFYING MOTOR FAULTS
PROBLEM POSSIBLE CAUSE REMEDIAL ACTION
The motor does not start, or starts Incorrect start procedure Note the information in
but does not continue to run. these operating instructions.
Incorrectly set Have the carburettor adjusted by
fuel/air mix on carburettor. authorised customer service.
Rusted spark plug Clean/adjust spark plug or replace.
Blocked fuel lter. Replace the fuel lter.
The motor starts but will not run at full Incorrect choke lever position. Set the lever to RUN (operation)
power.
Dirty air lter Remove lter, clean and insert anew.
Incorrectly set Have the carburettor adjusted by
fuel/air mix on carburettor. authorised customer service.
Motor runs unevenly. Incorrectly set spark gap Clean/adjust spark plug or replace.
on spark plug.
Incorrectly set carburettor Have the carburettor adjusted by
authorised customer service.
Excessively high noise. Incorrect fuel mixture. Use the correct fuel mixture (ratio 40:1)
Incorrectly set carburettor Have the carburettor adjusted by
authorised customer service.
EC Declaration of Conformity
We, ikra GmbH, Schlesier Straße 36, D-64839 Münster, declare under our sole responsibility that the product
petrol brushcutter BT 25, to which this declaration relates correspond to the relevant basic safety and health re-
quirements of Directives 2004/108/EC (EMC-Guideline), 2006/42/EC (Machinery Directive), 97/68/EC as amended
by 2004/26/EC (emmission directive, Anex IV) and 2000/14/EC (noise directive). For the relevant implementa-
tion of the safety and health requirements mentioned in the Directives, the following standards and/or technical
specication(s) have been respected:
EN ISO 11806-1:2011, EN ISO 14982:2009.
measured acoustic capacity level [dB(A)] 110,6
guaranteed acoustic capacity level [dB(A)] 112,0
Conformity assessment method to annexe V / Directive 2000/14/EC
The year of manufacture is printed on the nameplate and can be additionally retrieved via the consecutive serial number.
Münster, 21.09.2012
Gerhard Knorr, Technical Management Ikra GmbH
Maintenance of technical documentation: Gerhard Knorr, Kärcherstraße 57, DE-64839 Münster
To Next Page
Loading...
Need help?
General
