GB-1
ENGLISH
Hedge Trimmer
2. General safety instructions
Usage of hedge trimmer always involves a
risk of accidents, therefore please observe
the relevant accident prevention instruc-
tions.
The machine has been constructed according
to the latest technology and in accordance with
the recog-nised technical safety regulations.
Nevertheless, use of the machine can involve
risks to the user or third persons, and can cause
damage to the machine or other objects.
Attention: Using electric power tools, you must
observe following fundamental safety instruc-
tions to protect yourself against electric shock,
against danger of injuries and danger of re.
Read all these instructions before using the
hedge trimmer and observe them. Keep these
safety instructions at a safe place.
Use the machine in a safety conscious manner
for suitable applications in a technically perfect
condition only and with due regard to the oper-
ating instructions! Immediately rectify or have
rectied any faults which could adversely affect
safety!
This machine may cause serious injuries. Please
read the instruction manual carefully as to the
correct handling, the preparations, the mainte-
nance and the proper use of the hedgetrimmer.
Familiarize your-self with the machine before
the rst use and also have yourself introduced
to practical use of the machine.
This appliance is not intended for use by per-
sons (including children) with reduced physical,
sensory or mental capabilities, or lack of experi-
ence and knowledge, unless they have been
given supervision or instruction concerning use
of the appliance by a person responsible for
their safety.
Children should be supervised to ensure that
they do not play with the appliance.
1. Introducing the hedgetrimmer
Technical data HTMN 520
Operating Voltage V~ 230-240
Nominal Frequency Hz 50
Nominal Consumption W 520
Idle speed n
0
min
-1
1700
Cutting length mm 450
Cutting capacity mm 16
Weight (without ex) kg 2,5
Noise Pressure Level L
pA
according to EN 60745 dB (A) 79,9
[K 3,0 dB(A)]
Vibration according to EN 60745 m/s
2
4,0
[K 1,5 m/s
2
]
Class of protection: II / DIN EN 60745/VDE 0740
Emissions
- The specied vibration emission value was measured by a standardized test methods and can compare with other
power tools are used.
- The specied vibration emission value can also be necessary for the assessment of work breaks are used.
- The specied vibration emission value can vary during the actual use of the electric tool by specifying the value, de-
pending on the way how to use the power tool.
- Note: You create the privilege against vascular pulsations of the hands in time breaks.
The noise pressure level at the place of work can exceed 80 dB(A). In such cases the operator will require noise protec-
tion (e.g. wearing of ear protectors).
Attention: Noise protection! Please observe the local regulations when operating your device.
Interference suppressed in accordance with EN 55014, EN 61000-3-2, EN 61000-3-3.
We reserve the right to make changes to the technical specications.
The devices are manufactured in accordance with the provisions of EN 60745-1and EN 60745-2-15 and fully comply with the
provisions of the German Product Safety Act.
Translation of the original Operating Instructions
To Next Page
Loading...
Need help?
General
