illy SMART10 User Manual

26
Dispensing programmes
Small cup: Press and hold button (3). The machine will start dis-
pensing water. Release button (3) when the desired water level
has been reached. The machine will then stop dispensing water
and the quantity will remain stored for further dispensing. (Fig.9)
Large cup: Proceed as above also for button (2). (Fig.9)
NOTE: The minimum programming value is 10 seconds.
NOTE: Do not dispense with the tank empty.
If the tank empties while in use, immediately stop dispensing
and fill the tank.
IT IS ADVISABLE: For the preparation of a good espresso to
use thick and preheated cups, to prevent the coee from cool-
ing down too quickly. To preheat the cup, simply run a little hot
water from your home tap inside it.
After coee and drinks preparation
After coee and drinks have been prepared, the used capsule
is removed as follows:
• Lift the control lever backwards (the capsule falls into the cap-
sule container).
WARNING: for proper hygiene, it is recommended to re-
move the capsule just used.
Empty the container regularly.
• Use a new capsule to prepare another coee or drink and
repeat the process, otherwise close the lever again.
• When preparing a dierent drink from the one previously pre-
pared, in order not to alter its taste, it is advisable, after expel-
ling the used capsule, to dispense just water to eliminate any
possible residue.
Emptying the capsule holder
Empty the capsule holder regularly to prevent the capsules
from getting stuck.
To remove the capsule holder (6), pull and lift it simultaneously
(Fig.10). Once this operation has been carried out, separate the
drip tray from the capsule holder container by pulling it down-
wards, paying attention to any presence of liquid. Empty the
container, wash and dry the components before reinserting
them in their housings. (Fig.11)
STORING
If the machine is not used for a long period of time, disconnect
the power plug and empty the tank.
Store the appliance in a dry place, away from dust and out of
the reach of children.
It is recommended to store the device in its original packaging.
Store the machine at a temperature of not less than 5°C to pre-
vent water residues from freezing and damaging the machine.
Fig. 9
Fig. 10
Fig. 11
2
3
6
2
3
6
2
3
6

illy SMART10 Specifications

General

Brand	illy
Model	SMART10
Category	Kitchen Appliances
Language	English