illy SMART30 I - Page 23

INSTRUCTION MANUAL
23
21
•Use only capsules that are specific for this model
• Place a cup under the dispenser
• Slowly lift the control lever (1) backwards (until it stops)
(Fig. 9) and introduce a capsule in the slot provided (Fig. 10)
Preparation of coffee/tea/drinks
USEFUL TIP:
Use thick cups when preparing Espresso and heat them
beforehand. This will keep your coffee warm for longer. Cups
can be heated under hot running water.
Close the lever (1) completely and press one of the dispensing
buttons: short (A), long (B) according to your taste (Fig. 11)
NOTE
The machine is equipped with a pre-brewing system.
• Repeat the steps above for additional cups of coffee/tea
using a new capsule for each drink
•To extract the capsule, slowly lift the lever (1). If the capsule
is not ejected, repeat the operation or press the dispensing
button (A) and lift the lever (1) at the same time.
ATTENTION:
Before inserting the capsule, slowly and
completely lift the control lever (1) located on
the top of the machine. For correct hygiene and
to maintain high product quality it is indispensable
to eject the capsule immediately after dispensing.
Fig. 8
A
B
1
B
A
1
Fig. 11
Fig. 9
Fig. 10
Programming dispensing
Small cup: press and hold button (A). The machine will start
to deliver When the desired quantity has been delivered,
release button (A); the machine will end the delivery and the
set quantity information will be saved (Fig.8)
Large cup: press and hold button (B). The machine will start
to deliver When the desired quantity has been delivered,
release button (B); the machine will end the delivery and the
set quantity information will be saved (Fig.8)