21
Rev.13052022
TROUBLESHOOTING
If you have any problems with your appliance, you should check the troubleshooting prior to calling the Customer Care.
ILREF256/2
IF THE APPLIANCE IS NOT WORKING, YOU SHOULD CHECK:
• That there is power to the appliance.
• The house fuses are intact and the fuse in the plug has not blown.
• The appliance has not been turned off at the socket or on the control panel
• The plug socket is functioning ne. To check this, plug another electrical appliance in to see if the socket is faulty.
IF THE APPLIANCE IS WORKING, BUT NOT VERY WELL, YOU SHOULD CHECK:
• The appliance is not overloaded.
• The thermostat is set to an appropriate temperature.
• The doors are closing properly.
• The cooling system at the rear of the appliance is clean and free of dust, and not touching the rear wall.
• There is enough ventilation at the side, rear walls and underneath.
IF THE APPLIANCE IS NOISY, YOU SHOULD CHECK:
•The appliance is level and stable.
• The side and rear walls are clear, and there is nothing resting on the appliance.
NOTE:
The cooling gas in the refrigerator may make a slight bubbling or gurgling noise, even when the compressor is not running.
IF THE APPLIANCE IS BEEPING, YOU SHOULD CHECK:
• That the doors are closed. An alarm will sound after 60 seconds of a door being open.
IF EXCESSIVE ICE HAS FORMED IN THE FREEZER:
• Check that there is some resistance when opening the door of the appliance. If it opens at the slightest touch it may mean
that the door seal needs to be replaced or the appliance is incorrectly tted and this can be due to the decor door(s) not being
properly tted. If you are at all unsure, ask your tter to check the decor doors.
• Check the door seal for any kinks, debris or damage. If you notice any, and are unable to resolve the issue yourself, contact the
Customer Care so that the seal can be replaced.
• To ensure the appliance is level, you should use the height adjustable feet at the front of the appliance.
• The cooling system at the rear of the appliance must not touch the rear wall.
• The appliance must be installed with adequate ventilation. Ensure that there is clearance above the appliance to allow air to
escape and that there is space between the rear of the appliance and the wall.
• Adequate ventilation should be provided in the base of the unit to aid airow (Fig.6 (A))Recommended cut out of 300mm x
300mm.
IF ONE OR MORE OF THE LED UNITS WITHIN THE APPLIANCE IS NOT WORKING:
• Contact the Customer Care to arrange a service visit.
To Next Page
Loading...