5、Operating instructions
5.1. Preparation before operation
√ The machine head shall be in the stop state when the operator checks it
√ Clean the sundries on the machine table to ensure that there are no sundries hindering
the operation of the machine
√ Check the pressure of the air pressure gauge to make it meet the use requirements of
the machine
5.2. Operation process description
5.2.1 Boot device
Press 4.1-(1) power switch to ON ，Power on the device。
5.2.2 Motor detection
Click 4.1 - (3) - B touch screen monitoring interface button，The upper and
lower motors rotate at the same time, and the machine is normal。
5.2.3 Ultrasonic testing
Click 4.1 - (3) - B touch screen monitoring interface，The frequency is within
the normal range, the machine is normal,
5.2.4 Sewing
Place the cloth piece in the sewing area and press Four point one -(2) The right foot pedal
in, the machine starts to sew, release the foot pedal and the machine stops。
5.2.5 Shutdown
After operation, press the power switch to the off position, and the equipment will be shut
down。
To Next Page