CHANGING THE CONTROLLER SET POINT
The electronic temperature controller is factory set to 4°C and will cycle the air
temperature between 2°C and 6°C. The set point can be adjusted between 0°C
and 10°C by following the button sequence below:
USING YOUR BOTTLE COOLER
This unit is for cooling bottles and cans only. Do not load the cabinet with boxed
goods as this prevents air circulation and the goods will not cool down as
quickly. While loading ensure that the interior grilles are not obstructed by the
bottles.
Do not place hot or warm goods in the cabinet. Only goods at room
temperature or less should be placed in the unit, otherwise performance will be
affected. It is recommended that the cabinet is stocked after closing at night or
first thing in the morning to allow time for the bottles to cool. Ensure that stock
is rotated by placing new stock at the back of shelves or in one side of the
cabinet to ensure that colder bottles are served first.
Do not leave the doors open when the unit is running as this causes the
evaporator to ice up, preventing the unit from operating efficiently.
Ensure that the front grille is always unobstructed.
1)
Use the UP and DOWN buttons, to scroll to the
desired set point temperature (min 0°C, max 10°C)
2)
6
3)
4
4)
Press SET button and the current set point
temperature will be displayed
5
Then press stand-by button to esc.
Display will revert back to current
internal air temperature
4
Press SET the current SET Point will be displayed, if
Loc is displayed then the controller is locked, to
unlock press and hold the SET button for 3 seconds,
UnL will then be displayed
To Next Page
Loading...
Need help?
General
