There are 3 sections, Ethernet, Serial Port e Serial-TCP Bridge and a
command section with 4 keys in the bottom of the page.
Ethernet.
It contains the normal parameters to link a device to a Network TCP
- IP 192.168.1.100 default
- Subnet Mask 255.255.255.0 default
- GateWay 0.0.0.0 default
- Mode 10 default
Serial Port
To set the Baud Rate of the communication between the interface and the
devices :
- Speed 9600 baud default
- Parity None default
Serial-TCP
To set the working mode of the interface, the TCP Port and the connection
timeout
- Mode Bridge default
- TCP Port 502 default
- TCP Timeout 10 default
- Size 0 default (do not change)
- Char 0 default (do not change)
- Timeout 0 default (do not change)
After any change, press the button “Save and Reboot”.
To Next Page
Loading...
