iMediSync iSyncWave - Device Overview; How the Device Works

Product Specications General Instructions
• The following device and its systems are intended for a person who understands
the content written in English and understands the physical principle of EEG
or has received relevant training.
• Read all instructions and labels including this manual before operating the device.
• Refer to the user manual for the information on the recommended
tablet specications, operating system, and the requirements of those settings.
• iSyncWave is recommended to be operated by designated
personnel who received adequate training.
• Do not modify the device without consulting the iMediSync representative.
iMediSync will not be responsible for any malfunction or system failure
corresponding to any unauthorized modication and the warranty will be void.
Size
Amplier
Channels
Connectivity
Power
Weight
Bandwidth
EEG
Bluetooth
Battery
1600g
0.5 - 50 Hz
19 EEG Channels + Fpz Ground Channel
Bluetooth v5.0 (LE up to 2Mbps)
Rechargeable Li-lon Battery
245(L) x 243(W) x 153(H) mm
250 Hz
24 Bit
Right: 1 PPG Channel / Left: A1 Reference Channel
19 LED Bulbs (Built-in the center od each EEG
electorde)
USB-C Type with 5V/2A Adpater
50 cm - 62 cm
Analog Front End (AFE)
50 cm - 62 cm
Near-Infranred 850 nm
1 - 45 Hz (Adjustable in 1Hz Inceraments)
132 Min
7 Hours
Dimensions
Sampling Rate
A/D Converter
Auxiliary
Irradiance
Source
Charging
Head
Circumference
Special
Design
EEG Electrode
Wavelength
Pulse Rate
Charging Time
Runtime
• The manager of the device shall provide a safe environment
for a typical EEG system compliant to EN 60601-1-1 requirements.
• Always clean the electrodes after each or multiple measurements
according to the cleaning instructions.
• For electrode channels that has persistent problems with signal quality,
check the status of the electrode coating.
• In case of electrode replacements, only use the electrodes provided by the iMediSync, Inc.
Maintenance