15
EN
The suction power can also be changed by means of the manual adjusting device of
Closed: Increases the suction power.
Open: Reduces the suction power.
Hold the plug while winding the cable in order to prevent whiplash.
ATTENTION! The vacuum cleaner has a motor protection thermostat,
which intervenes in the case of overheating (caused by the inlet
opening, filters, etc. being clogged). If it is triggered, press the ON/OFF
(8) button to switch the appliance off and let it cool down completely
for a few hours. Verify whether dust has clogged the filters or the inlet
opening before restarting the appliance.
CLEANING AND MAINTENANCE
WARNING! Always disconnect the appliance from the mains
supply before cleaning or performing maintenance.
CAUTION! Periodicaly verify that filters and the inlet opening
are not clogged.
CAUTION! DO NOT use solvents or other aggressive or
abrasive detergents in order not to damage the appliance
surfaces.
CAUTION! Empty the dust container and clean the filters
after every use in order not to damage the appliance.
WARNING! Let the filters dry completely after washing them
for at least 24 hours before reassembly.
WARNING! Make sure all cleaned parts are completely dry
before reusing the appliance.
CLEANING THE APPLIANCE
When necessary, clean the appliance with a damp cloth.
With the motor ON, rub the brush with your hand to remove the dust and fluff, which will be
drawn.
CLEANING THE DUST COLLECTION SYSTEM (16)
To Next Page
