imex 88G - User Manual

Questions and Answers

P
Paul HudsonAug 9, 2025
What to do if the imex Laser Level is out of level and the battery light is on?
- H
  Heidi RodriguezAug 9, 2025
  If your imex Laser Level displays an out-of-level alert along with the battery light, and the instrument isn't working correctly, it might be due to harsh environmental conditions or direct sunlight. Move the unit to a shaded area where the temperature is below 50ºC.
M
Mike SandersAug 15, 2025
Why is my imex Laser Level receiver not working properly?
- D
  davidwaltonAug 15, 2025
  If the receiver for your imex Laser Level isn't functioning correctly, here are a few things to check: * First, ensure the receiver batteries are good and replace them if needed. * Second, verify that the receiver is within the working range (250m radius) of the unit. * Finally, make sure the laser windows are clean, free of dust, and not obstructed.
M
Melanie GuzmanAug 20, 2025
How to fix imex Laser Level remote control that is not working?
- C
  Craig GoodmanAug 20, 2025
  If the remote control for your imex Laser Level isn't working, try the following: * Check and replace the remote control batteries. * Ensure the remote is within the working range of the unit (20m outdoors, 30m indoors). * Verify that the instrument is turned on.
U
usalasAug 27, 2025
What to do if the imex 88G Laser Level shows a low battery light and won't operate?
- V
  vegabrianAug 27, 2025
  If your imex Laser Level shows a flashing low battery light and won't power on, try these steps: 1. Recharge the batteries. 2. If the batteries are fully charged but the unit still won’t operate, open the battery terminals to check if they are clean and have the correct polarity. 3. If the batteries have been overcharged frequently, they may need replacing.
D
Diana SotoSep 1, 2025
How to resolve an out of level alert on my imex 88G?
- A
  Andrea ClarkSep 1, 2025
  If your imex Laser Level displays an out-of-level alert and won’t self-level, ensure the instrument is within 5º of level before switching it on. Also, check that the manual level switch is not activated and that the unit hasn’t been bumped or moved.