What to do if the imex 88R is out of level and the battery light is on?
If your imex Laser Level displays an out-of-level alert along with the battery light, and the instrument isn't working correctly, it might be due to harsh environmental conditions or direct sunlight. Move the unit to a shaded area where the temperature is below 50ºC.
Why is my imex 88R Laser Level receiver not working properly?
If the receiver for your imex Laser Level isn't functioning correctly, here are a few things to check: * First, ensure the receiver batteries are good and replace them if needed. * Second, verify that the receiver is within the working range (250m radius) of the unit. * Finally, make sure the laser windows are clean, free of dust, and not obstructed.
How to fix imex 88R Laser Level remote control that is not working?
If the remote control for your imex Laser Level isn't working, try the following: * Check and replace the remote control batteries. * Ensure the remote is within the working range of the unit (20m outdoors, 30m indoors). * Verify that the instrument is turned on.
What to do if the imex 88R Laser Level shows a low battery light and won't operate?
If your imex Laser Level shows a flashing low battery light and won't power on, try these steps: 1. Recharge the batteries. 2. If the batteries are fully charged but the unit still won’t operate, open the battery terminals to check if they are clean and have the correct polarity. 3. If the batteries have been overcharged frequently, they may need replacing.
How to resolve an out of level alert on my imex 88R?
If your imex Laser Level displays an out-of-level alert and won’t self-level, ensure the instrument is within 5º of level before switching it on. Also, check that the manual level switch is not activated and that the unit hasn’t been bumped or moved.
Step-by-step guide for setting up and leveling the laser instrument on a tripod.
Instructions for setting up the laser receiver on a staff or grade rod.
How to activate and use manual grade mode for setting slopes.
Method and steps to set a specific percentage slope using the instrument.
Guide for setting simultaneous slopes on X and Y axes for specific models.
General| Power Source | 4 x AA batteries |
|---|---|
| Water/Dust Resistance | IP54 |
| Laser Diode | 635 nm |
| Power Supply | 4 x AA batteries |
| Operating Time | Up to 20 hours |
| Protection Rating | IP54 |
| Laser Class | Class 2 |
| Rotation Speed | 600 rpm |
To Next Page
