Appendix B: The Wizard - What else does it setup?
On startup the wizard will reset Cleanflight configuration to its default state.
Once completed the following features, configurations and mode will be injected in
Cleanflight so you can start to enjoy your Vortex straight off the box with zero additional
configuration needed:
Enabled, Throttle set to 1100
PPM Sum Mode (all channels down a single cable)
According to Wizard prompts
Default ImmersionRC settings (based on UmmaGawd’s tune)
NOTE: If you have ‘tweaked’ any Cleanflight settings outside of the Vortex OSD, please
remember to back them up before running the wizard the next time, since it will reset
them to default settings.
To Next Page
Loading...