Sept, 2019 IMPCO Technologies PPI-68 REV. E
3030 South Susan St. Page 10 of 15
Santa Ana, CA 92704
www.impcotechnologies.com
3030 S Susan Street, Santa Ana, CA 92704
Ph: +1 714 656 1200 Fax: +1 714 656 1400
9. Inspect the height of the secondary lever (23).
Using a ruler or straight edge, verify that the tip or
end of the lever rod is level or flush with the top of
the regulator body (2). If the lever requires
adjusting, DO NOT bend while installed (bending
may damage the valve seat). Remove the lever,
bend, reinstall, then recheck lever height.
10. Lay the regulator body (2) flat on a clean working
surface with the primary section up. Place the
primary spring (8) in the recess as shown.
NOTE: Repair kit T60-RK does not include the
primary spring; T60-RBK does.
11. Insert primary pin (12) into the primary lever (9).
NOTE: The Series I lever is shown on the left.
The Series I lever is included in both minor and
major repair kits preassembled with the seat rivted
into place.
To Next Page
Loading...
Need help?
General