Important: If you use the Clearyl filter and DECALCIFY
MACHINE appears, then the Clearyl Activation procedure
was not performed properly, see "J) Installing Clearyl...".
Important: Decalcifying program must not be interrupted.
Use only the special decalcifying tablets (not the cleaning
tablets!). For supplies see "N) Supplies".
1. Push
Rinse button. Display shows DURATION 45
MIN. / START YES
.
2. Push Rinse button again EMPTY TRAY.
3. Remove and empty tray and used coffee container
then replace, display shows
SOLVENT IN TANK.
Attention: If the tray and the used coffee container are
empty, you must remove the tray for approx. 20 seconds and
then replace it.
4. Remove frothXpress system.
5. Remove the water container and empty.
6. Completely dissolve 3 large square decalcifying tablets in
a container with 20 oz. of water (0.6 liters) and pour the
solution into water tank.
7. Replace water tank.
SOLVENT IN TANK/PRESS RINSE
8. Place containers under the Auto Cappuccino system and
the hot water spout.
9. Push the
Rinse button. Display shows DECALCS and
the light in the Rinse button flashes. The machine pumps
the solution in intervals through the Cappuccino system
and the Hot Water Spout.
10. When display shows
EMPTY TRAY, remove and empty
the containers. Then carefully remove and empty the tray
and the used coffee container and replace.
11. Display shows
RINSE WATER TANK/FILL WATER TANK.
Remove water tank, rinse thoroughly, fill halfway with
fresh water and replace. Display shows
PRESS RINSE.
12. Place containers under the Auto Cappuccino System and
the Hot Water Spout / coffee spouts.
13. Push the
Rinse button DECALCS.
14. The machine pumps fresh water through the system and
stops automatically. Display shows
HEATING UP. When
display shows MACHINE RINSING, hot water will flow
through the coffee spouts. EMPTY TRAY.
15. Remove and empty the containers. Then carefully remove
and empty the tray and the used coffee container and
replace.
COFFEE READY.
The machine will automatically remind you when it’s time to
decalcify again.
N) Supplies can be ordered through:
Customer Service, Mail Order Form or www.capresso.com
• Clearyl Water Filter Cartridge: #64553
• Cleaning Tablets: #62205
• Decalcifying Tablets: #66281
JURA-CAPRESSO CUSTOMER SER
VICE: 1-800-220-5701
M-F 9AM - 9PM; Sat. 9AM - 5PM EST
FAX: 201-767-9684 contact@capresso.com
Impressa S9 One Touch Quick Reference Guide
This Guide does not replace the Operating Instructions.
For details and cautions you must read all instructions.
Traces of Coffee Grounds in New Machine?
This is normal! Grinder was tested during assembly with beans.
Despite cleaning, traces of ground coffee may be found.
RED TEXT represents display text.
A) First Time Ever Preparation
1. Fill water in tank and beans in bean container.
2. DO NOT install the Clearyl Filter Cartridge now!
3. Push the main power switch in the back of the machine.
4. Push the ON/OFF button in the display. When the display
reads
FILL SYSTEM / PRESS STEAM place a cup under
the frothXpress and push the
Rinse button.
SYSTEM FILLING then HEATING UP. PRESS RINSE.
5. Place a cup under the coffee spouts and press the RINSE
button. MACHINE RINSING. COFFEE READY.
6. Place a large cup underneath the coffee spouts and press
the
1-CUP coffee button. 1 COFFEE: The machine
starts grinding and brewing. Repeat once. Discard the first
two cups of coffee.
B) Daily Preparation
1. Fill fresh water in tank and check bean container.
2. Push ON/OFF button. HEATING UP. PRESS RINSE. Place
a cup under the coffee spouts and press the RINSE button.
MACHINE RINSING. COFFEE READY.
Important: You can only brew coffee when display shows
COFFEE READY.
C) Grinding and Brewing Coffee
Four pr
e-set coffee buttons:
1 ESPRESSO, 2 ESPRESSI,
1 COFFEE, 2 COFFEES. These buttons are pre-set for
strength (five settings), cup size (1 to 8 oz. per cup) and
temperature (HIGH, NORMAL). In programming you can
change all three functions.
To brew coffee:
K. Replacing the Clearyl Cartridge
When display shows COFFEE READY /CHANGE FILTER
and the Rinse button lights up:
• Push
Rinse button. DURATION 2 MIN. / START YES.
• Remove water tank, remove old filter. Keep the
extension rod. Rinse new filter under running water,
attach to extension rod and install in water tank. Fill
tank with fresh water and replace.
• Now proceed as explained in steps 4 through 6 above.
L)
Cleaning with Special Tablet (Machine is on)
The message
COFFEE READY / CLEAN MACHINE
appears after 220 cups of coffee. This program removes
coffee oils inside the machine and takes 20 minutes.
Important: Do not interrupt program once started.
Important: Only use special round cleaning tablet.
1. Push Rinse button. DURATION 20 MIN. / START YES.
NOTE: To clean the S9 OT later, turn the Rotary Dial
until display shows
START NO. Push the Rotary Dial to
exit the program. In this case the S9 OT will continue to
remind you with the message CLEAN MACHINE.
2. Make sure that the water container is at least half full.
3. Push the
Rinse Button. EMPTY TRAY.
4. Remove and empty the tray and the used coffee
container and replace.
Attention: If the tray and the used coffee container are
already empty, you still need to remove the tray for
approx. 20 seconds and then replace it.
PRESS RINSE.
5. Place containers (20 oz.) under the coffee spout and the
frothXpress and push the
Rinse button. Display shows
CLEANS. After a short while you will hear a beep and
display shows
ADD TABLET/PRESS RINSE.
6. Open the ground coffee funnel lid and drop one white
tablet into the opening. Close lid.
7. Push the
Rinse button. Display shows CLEANS.
The S9 OT starts the cleaning program by dispensing
water in intervals into the containers underneath the
spouts. When finished, display shows
EMPTY TRAY.
8. Remove the tray. There will be water in the tray and in
the used coffee container. Empty, clean and replace.
The display shows
COFFEE READY.
9. Clean the ground coffee funnel. Remove the funnel and
rinse under hot water and dry Replace funnel.
M) Decalcifying DECALCIFY MACHINE
For different water hardness levels see Operating
Instructions (page 21). If a water hardness level is selected,
the decalcifying monitor is active. The machine needs to
be decalcified when above message appears.
CAUTION: Immediately remove any splashes of the
decalcifying solution from sensitive surfaces, such as
natural stone or wood.
CAUTION: If the decalcifying solution comes in contact
with the skin, rinse it off with water. If the solution comes
in contact with your eyes, see a doctor.
To Next Page
Need help?
General
