11
TO USE THE UV SANITIZER
1) After steam cleaning, remove the jewelry from the stainless steel basket and open the
side door to the UV chamber. There are 3 hangers inside to hang rings, earrings or other
accessories. Close the side door. Press the UV buon“
”. The UV light will operate for a
30-minute cycle and then automacally shut o with a beep indicator. You can shut o the
UV light if 30 minutes is not required, by pressing the buon a second me.
NOTE: If your item is not designed to hang, you may place it on the base of the UV chamber. It
is recommended that you rotate your item so light hits all sides of the item.
NOTE: In order to kill 99.9% of all bacteria such as E. coli, Staphylococcus and Salmonella,
30 minutes is required for full sanizaon.
NOTE: The UV Light will shut o automacally if you open the side door during the
UV cycle to avoid UV leakage. Once the side door is closed, the UV light will turn back
on to connue sanizing for the remaining UV cycle.
2) When nished sanizing, press the power on/o buon to shut the appliance o. Unplug
power cord from outlet. Allow remaining water in the water tank to cool for approximately
30 minutes. Slowly unscrew the water tank cap to release any remaining pressure. Turn the
unit upside down over a sink to drain the water tank and ultrasonic reservoir.
To Next Page
Loading...
Need help?
General