9
6) Put the measuring cup on the base plate below the steam nozzle; put the stainless steel
basket on the measuring cup. Make sure all loose parts are securely in place.
7) Plug in unit. The power bu on will begin to ash. Press the power on/o bu on once to
power on unit. The on/o bu on will stop ashing.
TO USE THE ULTRASONIC CLEANER
NOTE: It is recommended that another high wa age appliance is not operated on the
same circuit to avoid a circuit overload.
WARNING: Never run the ultrasonic reservoir without water.
1) Place the jewelry or accessories into the ultrasonic reservoir.
2) Press the ultrasonic bu on“
” on the control panel to turn on.
3) Ultrasonic will shut o a er 5 minutes automa cally with beep indicator. You can shut
o the ultrasonic func on if 5 minutes is not required by pressing the ultrasonic bu on
a second me.
4) Items that are very dirty should be cleaned rst in the ultrasonic reservoir and then
with the steamer.
5) While wai ng for the ultrasonic cleaning, press the steam on/o bu on for hea ng.
After ultrasonic cleaning is done, using the tweezers, remove the jewelry from the
ultrasonic reservoir and put them in the stainless steel basket. You may also hold the
jewelry by using the tweezers during steam cleaning.
TO USE THE STEAMER
WARNING: Never run the steamer without water.
1) Press the steam on/o bu on“ ” allowing the steam pressure to build-up.
2) The steamer may be used as soon as the steam-ready light has turned RED.
To Next Page
Loading...
Need help?
General