In Phase IPS 248BT - Contact Management and Call Settings; Adding, Finding, and Deleting Contacts

11
Adding Contacts
The unit can save contact telephone number for quick access.
1. Press and hold PHONE on the dial keypad then press and hold SEL button for 2 seconds.
2. Press SEL button repeatedly until “ADD NUM” displays.
3. Press and hold SEL button again.
4. Using volume knob, enter the name of the contact. Press SEL button to save each character en-
tered.
5. Enter the phone number. Press SEL button to save each number entered.
6. Press and hold SEL button to save entry.
Finding Contacts
After adding contacts, you can use this feature to find them.
1. Press and hold PHONE on the dial keypad then press and hold SEL button for 2 seconds.
2. Press SEL button repeatedly until “FIND NUM” displays.
3. Press and hold SEL button again.
4. Using volume knob, select the name of the contact and press to call.
Deleting Contacts
1. Press and hold PHONE on the dial keypad then press and hold SEL button for 2 seconds.
2. Press SEL button repeatedly until “FIND NUM” displays.
3. Press and hold SEL button again.
4. Rotate VOL knob until the name of the contact you want to delete displays.
5. Press and hold “ ” for 2 seconds to delete contact.
How to Set Incoming Call Melody
1. Press and hold PHONE on the dial keypad then press and hold SEL button for 2 seconds.
2. Press SEL button repeatedly until “MELODY” displays.
3. Rotate VOL knob to the desired melody.
How to Set Incoming Call Ring Volume
1. Press and hold PHONE on the dial keypad then press and hold SEL button for 2 seconds.
2. Press SEL button repeatedly until “RING” displays.
3. Rotate VOL knob to the desired level.
How to Set Conversation Volume
1. Press and hold PHONE on the dial keypad then press and hold SEL button for 2 seconds.
2. Press SEL button repeatedly until “TEL” displays.
3. Rotate VOL knob to the desired level.
Disconnect Paired Devices
You can disconnect to an already paired Bluetooth device from your car stereo.
1. Press and hold PHONE on the dial keypad then press and hold SEL button for 2 seconds.
2. Press SEL button repeatedly until “DISCONN” displays.
3. Press and hold SEL button again to disconnect.
• RESET
Reset button is placed on the housing.
The reset button is to be activated for the following reason:
• Initial installation of the unit when all wiring is completed.
• All the function button do not operate.
• Error symbol on the display.
RESET