Inalto Classique IDW604W - Error Codes; Error Code Meanings and Causes

PAGE 30
If there is a malfunction the dishwasher will display error codes to identify the fault.
Code Indicator Meanings Possible Causes
The Rapid program
LED indicator
flashes repeatedly
and the buzzer
sounds.
E1- Water entering the
dishwasher has exceeded
the pre-set time, or the flow
of water into the dishwasher
is restricted.
Ensure that the water supply hose is un-kinked and that
the water supply tap is fully open.
The Rapid & 90
Min program LED
indicators flash
repeatedly and the
buzzer sounds.
E3- The dishwashers on
board sensors have detected
that the water isn't reaching
the desired temperature
within the pre-set time.
Potential malfunction of the heating element. Try turning
the appliance power o at the power point for 15 minutes
before re-starting. If issue persists, please contact our
Customer Care team.
The ECO program
LED indicator
flashes repeatedly
and the buzzer
sounds.
E4- Overflow. The onboard
computer has detected
a leak (correctly or
incorrectly).
Contact our Customer Care team.
The ECO & 90
Min program LED
indicators flash
repeatedly and the
buzzer sounds.
E6- Potential component
failure.
Try turning the appliance power o at the power point
for 15 minutes before re-starting. If issue persists, please
contact our Customer Care team.
WARNING! If the E4 Overflow error is occurring, turn o the main water supply at the tap as a pre-caution, before
calling our Customer Care team.
Note. If there is water in the base of the dishwasher because of an overfill or small leak, the water should be
removed before re-starting the dishwasher.
Error Codes