PAGE 30
If there is a malfunction the dishwasher will display error codes to identify the fault.
Code Indicator Meanings Possible Causes
E1 will be displayed
on the LED display
and the buzzer will
sound.
Water entering the dish-
washer has exceeded the
pre-set time, or the flow of
water into the dishwasher is
restricted.
Ensure that the water supply hose is un-kinked and that
the water supply tap is fully open.
E3 will be displayed
on the LED display
and the buzzer will
sound.
The dishwashers on board
sensors have detected that
the water isn't reaching the
desired temperature within
the pre-set time.
Potential malfunction of the heating element. Try turning
the appliance power o at the power point for 15 minutes
before re-starting.
Also ensure the filter system is clean and free of foreign
objects (such as broken glass).
Check the drain hose isn’t kinked or blocked.
If issue persists, please contact our Customer Care team.
E4 will be displayed
on the LED display
and the buzzer will
sound.
Overflow. The onboard com-
puter has detected a leak
(correctly or incorrectly).
Check that your dishwasher is level, an un-level dishwash-
er can trigger this alarm.
If the problem persists Contact our Customer Care team.
E6 will be displayed
on the LED display
and the buzzer will
sound.
Potential component failure. Try turning the appliance power o at the power point for
15 minutes before re-starting.
If issue persists, please contact our Customer Care team.
E7 will be displayed
on the LED display
and the buzzer will
sound.
Potential component failure. Try turning the appliance power o at the power point
for 15 minutes before re-starting. If issue persists, please
contact our Customer Care team.
WARNING! If the E4 Overflow error is occurring, turn o the main water supply at the tap as a pre-caution, before
calling our Customer Care team.
Note. If there is water in the base of the dishwasher because of an overfill or small leak, the water should be
removed before re-starting the dishwasher.
Error Codes
To Next Page
Loading...
